气体增压泵安装时应该注意哪些问题

1.安装：气体增压泵安装过程中，请参考技术参数中的各接口尺寸，避免异物进入泵内，保持进出口的清洁。1. Installation: gas booster pump installation process, please refer to the technical parameters of each interface dimension, avoid foreign bodies into the pump, maintain the cleanness of the import and export.2.气源质量标准：请选择洁净气源，以保证泵能持续稳定的工作。气源请满足下表要求：2. The air quality standards: please select clean air, to ensure that the pump can work steadily. Air please meet the requirement in the table below:3.气源润滑：气体增压泵在出厂时，所有运动部分已经抹有适量润滑油，一般不再需要润滑，如长期使用干燥的压缩气体驱动，建议在二联体的油杯内加入适量的润滑油，进行油雾润滑。3. Air lubrication, gas booster pump in the factory, all moving parts have to have a moderate amount of lubricating oil, generally no longer need lubrication, such as long-term use of dry compressed gas drive, suggest that in the second couplet body add lubricating oil in the oil cup, oil mist lubrication.4.气源压力：气体增压泵的最小驱动压力为1.5-2bar，最大设计驱动压力为10bar。建议使用气压在6-8bar之间。可通过调整调压阀的压力，以达到需求的使用压力。4. Air pressure: the minimum driving pressure gas booster pump is 1.5-2 bar, the maximum design driven pressure to 10 bar. Recommend the use of air pressure between 6 to 8 bar. By adjusting the pressure regulating valve, in order to achieve the use of demand pressure.泵的驱动压力绝对不能超过10bar，如果是通过管道气进行驱动的，一定有可靠的减压阀及安全阀。Pump driven by pressure must not more than 10 bar, if is driven by gas pipeline, there must be a reliable pressure reducing valve and relief valve.5.连接管路：根据气体增压泵http://www.xinmingte.com/的输出压力、流量，选择合适的进出口连接管路，确保能承受泵的最大输出压力、流量。泵的驱动口连接管路通径应略大于泵的驱动口连接螺纹的公称尺寸，如果连接通径变小，将极大地影响泵的工作效率！5. Connect line: according to the output of the gas booster pump pressure, flow, select the appropriate connection line of imports and exports, to ensure that can withstand the maximum output pressure and flow of the pump. Pump drive mouth connection pipe size should be slightly bigger than the pump drive joint thread nominal size, smaller, if the connection size will greatly influence the work efficiency of the pump!

当前位置：首页 >> 公司动态 >> 行业资讯发布时间： 2014-08-25
上一篇：气体增压泵增压系统典型应用下一篇：气体增压泵解决了工厂内部气源压力不足的问题